ESP32 DevKitC NRF24L01 PA LNA 2.4GHz Development Board Bluetooth Wi-Fi Signal Support Type-C Adapter Board

Features 1 This hardware is solely intended for learning purposes 2 After connecting the Type C to a 5V power supply press the switch button on the adapter board from OFF to ON simultaneously press the RST reset button on the ESP32 development board it is now ready for use Note This product is only for learning purposes Please abide by local laws and regulations Specifications Product ESP32 DevKitC NRF24L01 PA LNA 2 4GHz Module Development BoardFrequency 2 4GHzModule support Bluetooth blocker signal and Wifi supportPower supply Type C to 5V power supplySwitch operation Press the switch button on the adapter board from OFF to ONReset operation Press the RST reset button on the ESP32 development boardIntended use Solely for learning purposesPlease note that you must ensure the 8 pin connector is aligned before inserting it to turn on power Otherwise a short circuit may occur For 2x4 pin connectors simply align them correctly and insert them Operating steps 1 Turn on the switch 2 Plug in the power operating current approximately 5V 0 4A which can disconnect the communication between the phone and the Bluetooth speaker 3 After powering on press the EN button You can then check if the phone s Bluetooth or the Bluetooth speaker has disconnected The other button is the boot button You only need to press the boot button when flashing the firmware otherwise it will have no effect Tips 1 Pressing and releasing the EN button for two seconds will restart