Kingston KVR16LN11/4 4GB 1600MHz DDR3L CL11 1.35V

This document describes ValueRAM's 512M x 64-bit (4GB) DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 1Rx8, low voltage, memory module, based on eight 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows: FEATURES JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power SupplyVDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)800MHz fCK for 1600Mb/sec/pin8 independent internal bankProgrammable CAS Latency: 11, 10, 9, 8, 7, 6Programmable Additive Latency: 0, CL - 2, or CL - 1 clock8-bit pre-fetchBurst Length: 8 (Interleave without any limit, sequential with starting address 000 only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]Bi-directional Differential Data StrobeInternal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm 1%)On Die Termination using ODT pinAverage Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95CAsynchronous ResetPCB Height: 0.740 (18.75mm) or 1.180 (30.00mm), single sided componentCL(IDD)11 cyclesRow Cycle Time (tRCmin)49.125ns (min.Refresh to Active/Refresh Command Time (tRFCmin)260ns (min.)Row Active Time (tRASmin)36ns (min.)Maximum Operating Power(1.35V) = 2.160 WUL Rating94 V - 0Operating Temperature0o C to 85o CStorage Temperature-55o C to +100o CNotePower will vary depending on the SDRAM used.* Specifications are subject to change without notice. * Specifications may vary.* The product picture(s) is only for your reference, it may differ from the actual product.