Kingston ValueRAM 4GB(1x4GB) DDR3-1600 PC3L-12800 Memory

KVR16LN11/4 4GB 1Rx8 512M x 64-Bit PC3L-12800 CL11 240-Pin DIMM

DESCRIPTION This document describes ValueRAM's 512M x 64-bit (4GB) DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 1Rx8, low voltage, memory module, based on eight 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:

FEATURES

• JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power Supply

• VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)

• 800MHz fCK for 1600Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 11, 10, 9, 8, 7, 6

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C

• Asynchronous Reset

• PCB Height: 0.740” (18.75mm) or 1.180” (30.00mm), single sided component

SPECIFICATIONS

CL(IDD): 11 cycles

Row Cycle Time: (tRCmin) 48.125ns (min.)

Refresh to Active/Refresh: 260ns (min.)

Command Time (tRFCmin)

Row Active Time (tRASmin): 35ns (min.)

Maximum Operating Power: (1.35V) = 2.160 W*

UL Rating: 94 V - 0

Operating Temperature: 0o C to 85o C

Storage Temperature: -55o C to +100o C