Thermaltake Pacific F-Pro Hard Tube 16mm OD Compression Chrome

The Thermaltake Pacific F-Pro Hard Tube 16mm OD Compression Chrome features a mirror-polished copper finish, elevating the aesthetics of custom liquid cooling systems. It is compatible with 16mm outer diameter hard tubing made from PCTG, PETG, acrylic, or glass and utilizes G1/4 threading for secure connections. The fitting includes four O-rings to ensure a leak-free seal and reliable performance in water-cooling loops.

Features

---

Pacific F-Pro Hard Tube 16mm OD Compression - Chrome

Sleek Mirror Polished Design

The Pacific F-Pro Fittings undergo a meticulous treatment, resulting in a flawless mirror-polished surface. This premium design enhances visual appeal, elevating custom liquid cooling configurations aesthetics with a stylish and concise look.

Easy and Reliable Installation

Pacific F-Pro Hard Tube 16mm OD Compression can be used with PCTG, PETG, Acrylic, and Glass tubes with 16mm in outer diameter (OD), and it is compatible with G1/4 screw threads. Equipped with four O-Rings, it ensures a more secure seal and reliable performance to build water-cooling loops.

Caution: For added convenience during installation, consider wearing non-slip gloves to ensure secure grip while tightening and adjusting fittings.

Thermaltake Pacific F-Pro Fittings Installation Guide

• Step 1: Slide the compression nut over the tube
• Step 2: Install the O-Ring
• Step 3: Install the packing
• Step 4: Install the fitting base on your components
• Step 5: Tighten the compression nut

Caution: The O-Ring and the packing with a groove on the inside diameter must always be installed towards the top of the compression nut.

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

• To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
• Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
• It is strongly recommended to use market proven pre-mix coolant, such as
• Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
• Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

• It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminium, and steel – from corrosion.
• Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
• DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
• Fill the reservoir to the top as it will prevent air from going into the pump
• If necessary tilt the system slightly from side to side to bleed the air out of the loop.
• Place some paper towels under fittings and joining points to test for leaks.
• Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
• Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
• Coolant might fade over time.